Error with Cu3er 3D

[xaman]

Hi,

I just installed this module on my website, but it gives an error message and doesn't display the articles. The error is:

Can not write file

Anyone knows how to fix this?

[linhpdt]

Hi xaman,

Please chmod to 777 for "modules/mod_jv_cu3er/assets/config/" folder and 666 for "modules/mod_jv_cu3er/assets/config/config.xml" file!

Best regards,
Linh

[xaman]

Thanks for that. But now it shows the "cuber" and nothing else. No articles, no images, nothing...

[covandenham]

Thanks for that. But now it shows the "cuber" and nothing else. No articles, no images, nothing...

I have the same put all on 777 and config.xml on 666 and only the cuber is displayed, what to do?

[kernera]

I have the same put all on 777 and config.xml on 666 and only the cuber is displayed, what to do?

Same here!

Is there a user guide available for this module?

[hieuja]

Hello everybody,

Module Cu3er 3D is only active when the article has at least one image (all articles in selected categories). Please check your articles again.

Thanks and best regards.
HieuJa

[xaman]

Hello everybody,

Module Cu3er 3D is only active when the article has at least one image (all articles in selected categories). Please check your articles again.

Thanks and best regards.
HieuJa

Yes, that's the case and it still doesn't work.

[kernera]

I tried the module on 2 different templates.

It works on ja_Lead (position ja-slidewhow)
But it does not work on ja_Pyro (possition Top)

I need it to work on ja_Pyro template

[hieuja]

Yes, that's the case and it still doesn't work.

I tried the module on 2 different templates.

It works on ja_Lead (position ja-slidewhow)
But it does not work on ja_Pyro (possition Top)

I need it to work on ja_Pyro template

Hello,
Please give me the administrator of your site via private message.
I will check it out.
Regards.

[kernera]

Just for the record,

HieuJa checked my settings and found out the template Ja_Pyro had bugs in it. So It was not the module Cu3er 3D to blame.

I then installed the module on another website using same template (Ja_Pyro) and Cu3er 3D worked fine there.

Thanks for the support